3
Electron Microscopy Sciences
1560 Industry Road Hatfield, PA 19440 P.O. Box 550
TEL: 215-412-8400 FAX: 215-412-8450
EMAIL: sgkcck@aol.com WEB: www.emsdiasum.com
To prevent damage to the unit:
- Charge your solution regularly.
- Do not cover vents on the cover.
- Do not operate the unit dry.
- Do not place parts or containers directly on the bottom of the tank; use a tray or wire to suspend
items. Failure to comply may cause transducer damage and will void your warranty.
- Do not allow the solution to drop more than 3/8 inch (1cm) below the operating level line with heat
or ultrasonics on. Failure to comply may cause transducer and/or heater damage and will void
your warranty.
- Turn off AC and heater switch before plugging/unplugging the line cord.
Sound level and energy savings:
- Do not operate the unit without a cover when possible.
- The sound pressure released by the unit depends on the size of the bath and the application, but
is less than 80 dBA when used with a cover.
- To reduce the sound pressure, it is recommended to use a cover while ultrasonics are activated
and to switch the ultrasonics on with the bath loaded when possible.
To Next Page
