7
Electron Microscopy Sciences
1560 Industry Road Hatfield, PA 19440 P.O. Box 550
TEL: 215-412-8400 FAX: 215-412-8450
EMAIL: sgkcck@aol.com WEB: www.emsdiasum.com
Operating your Ultrasonic Bath
If this is the first time you are using the ultrasonic bath, please read this whole section before operating
your unit.
M Series: Before you begin
Select your cleaning solution.
Allow for the volume of the parts you will be cleaning and leaving room for the cleaning solution,
fill the tank with warm tap water to the operating level line.
Add cleaning solution to the tank water.
Plug the unit into a grounded outlet.
For maximum efficiency, refer to “Optimizing your Ultrasonic Bath” before proceeding.
CAUTION
- Do not place parts or containers directly on the bottom of the tanks; use a tray or wire to suspend items.
Direct placement can cause the units to fail.
- Do not allow the solution to drop more than 3/8 inch (1 cm) below the operating level line with ultrasonics
on.
- Do not ever use alcohol, gasoline, or flammable solutions. Do son could cause a fire or explosion. Use only
water-based solutions.
- Do not ever use mineral acids. These could damage the tank.
Failure to comply with these cautions will void your warranty.
NOTE:
If this is the first time you are running the unit, or if you have changed cleaning solution, you must degas
the solution. If not, skip to “Cleaning items (Treating samples)”.
To Next Page
Loading...
