1
Before using your Ultrasonic Bath, please read and thoroughly
understand these safety precautions. Failure to follow them may result in
serious personal injury or property damage.
To avoid electrical shock:
• Do unplug from power source before filling or emptying the tank.
• Do plug the unit into an appropriate grounded power socket.
• Do connect the unit to a power supply using a properly sized
overcurrent protection device. See label on the back of unit for
information on current rating.
• Do keep the control panel and the area around the unit clean and
dry—wipe up solution which spills over the tank brim. Water and high
voltage can cause electrical shock.
• Do not operate the unit without proper grounding.
• Do not remove the grounding prong on the line cord plug.
• Do not disassemble your unit—high voltage inside the unit is
dangerous.
• Do not immerse the unit in water.
To prevent personal and/or property damage:
• Do use water-based solutions.
• Do not ever use alcohol, gasoline or flammable solutions. Doing so
could cause a fire or explosion and will void your warranty. Use only
water-based solutions.
• Do not ever use mineral acids. These could damage the tank.
• Do not touch the stainless steel tank or cleaning solution—they may
be hot.
• Do not allow fluid temperature to exceed 70 °C (158 °F).
• Do not place your fingers or hands into the tank while the unit is
operating. Doing so may cause discomfort and possible skin irritation.
Avoid contact with solutions and provide adequate ventilation.
• Do not use solutions containing chlorine bleach.
Safety Precautions
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
