Brasilia OPUS - User Manual

Other manuals for Brasilia OPUS

Technical Manual56 pages

Questions and Answers

T
Tammy StaffordSep 10, 2025
Why supply does not occur in regular doses in Brasilia OPUS Coffee Maker?
- J
  Joshua BaldwinSep 10, 2025
  If supply does not occur in regular doses in your Brasilia Coffee Maker, it could be due to several reasons: * There is a leak in the volumetric doser. If there is humidity outside the doser and in the diode-holder flange, replace the doser. * The doser rotor does not rotate freely. Replace the doser. * The supply solenoid valve leaks from the drain. Check and replace if necessary. * The expansion valves leak during supply. Check the calibration and if necessary the gasket. Caution: Do not unscrew the regulation connector of the expansion valve fully while the boiler is pressurised. Check and replace if necessary.
C
Christopher McgeeAug 23, 2025
Why no water comes out of the group and the pump is noisy in Brasilia OPUS?
- A
  Amanda LeeAug 23, 2025
  If no water comes out of the group and the pump is noisy in your Brasilia Coffee Maker, it could be due to the mains or purifier taps being turned off. Ensure these taps are open. Another cause could be a blocked water inlet connector filter; remove and clean it.
J
James GilbertAug 25, 2025
What to do if the water level rises and leaks from the safety valve in Brasilia Coffee Maker?
- L
  Larry CalhounAug 25, 2025
  If the level of water in the boiler continues to rise until leaking out of the safety valve in your Brasilia Coffee Maker, it could be due to several reasons: * The level probe may not be connected; check and replace if necessary. * There might be a foreign body inside the auto-level solenoid valve; check and replace if necessary. * A foreign body might be inside the seal site; check it. * The gasket may be worn; check and replace if necessary.
J
Jennifer SpencerAug 26, 2025
What to do if no water comes out of the group of Brasilia Coffee Maker?
- C
  colebarbaraAug 27, 2025
  If no water comes out of the group in your Brasilia Coffee Maker, it could be due to several reasons: * The gicleur is blocked. Remove the gicleur cap, check, clean or replace it if necessary. * The injector is blocked. Remove and clean it, replace if necessary. Note: check purifier resin regeneration. * (only for versions with volumetric dosage) The doser inlet connector is blocked. Remove and clean it. * The solenoid valve does not open due to no power reaching the coil, an interrupted coil, or a blocked core. Check the solenoid valve, reset the electrical connections, or replace the coil. It is advisable to replace the whole solenoid valve.
A
ashley68Aug 28, 2025
Why the group does not heat up in Brasilia OPUS Coffee Maker?
- J
  Jennifer DixonAug 28, 2025
  If the boiler is pressurized but the group does not heat up in your Brasilia Coffee Maker, it could be because air has not been removed from the boiler during the water heating phase. When the machine is cold, check that the air vacuum valve is not blocked shut and replace if necessary. Alternatively, the thermosiphon circuit may be partially blocked. Check the group supply and return tubes and connectors, and clean or replace them if necessary. Note: check purifier resin regeneration.
T
Theresa HartAug 29, 2025
How to fix visual level not indicating real water level in Brasilia OPUS Coffee Maker?
- J
  Jeffrey HowellAug 29, 2025
  If the graduated visual level does not indicate the real level of water in the boiler of your Brasilia Coffee Maker, the lower tube which connects the level to the boiler may be blocked. Disassemble and clean it.
D
debra30Sep 18, 2025
Why water leaks from the block ring nut during manual filling in Brasilia OPUS Coffee Maker?
- H
  Heidi Hale DVMSep 18, 2025
  If water leakage occurs from the block ring nut during manual filling in your Brasilia Coffee Maker, it's likely due to a faulty tap gasket. Replace it.
A
Alejandro FletcherSep 12, 2025
Why water and steam nozzles leak when taps are off in Brasilia OPUS?
- K
  ksolisSep 12, 2025
  If leaks from the water and steam nozzles occur while the relative taps are turned off in your Brasilia Coffee Maker, it's likely due to a faulty seal or a foreign body present in the seal site. Check and replace if necessary.
D
Donald WhiteSep 8, 2025
Why Brasilia OPUS Coffee Maker only supplies when the resistance is powered?
- S
  Samuel GilmoreSep 8, 2025
  If the Brasilia Coffee Maker only supplies when the resistance is powered electrically (red light on), the “neutral” may be missing in the electrical power supply. Check and re-establish it.
B
Brenda RoseSep 5, 2025
What to do if auto-level doesn't take water and the light is on in Brasilia Coffee Maker?
- M
  Matthew ButlerSep 5, 2025
  If the auto-level does not take in water when it should, and the warning light is on in your Brasilia Coffee Maker, it could be that the filling solenoid valve coil has been interrupted. Check and replace if necessary. Alternatively, the core of the filling solenoid valve may be interrupted; check and replace if necessary.