Why won't the group deliver in my Brasilia Coffee Maker?
If the boiler gets up to pressure but the group will not deliver on your Brasilia Coffee Maker, the control centre fuses might be shot (dosed version), the delivery switch might be defective, or the solenoid valve might not open. Check and replace these components if necessary.
What to do if water level in Brasilia EXECUTIVE boiler keeps rising?
If your Brasilia Coffee Maker's boiler continues to fill with water until it escapes from the safety valve, the level sensor might not be connected properly. Check and replace if necessary. Also, there might be a foreign body inside the water level control solenoid valve or in the seal housing. Check and replace these parts as needed. Finally, inspect the seal for wear and replace it if necessary.
Why is the pump noisy and the group not delivering water in my Brasilia EXECUTIVE?
If your Brasilia Coffee Maker group does not deliver water and the pump is noisy, the water mains tap or the softener taps might be shut. Open the taps. Alternatively, the water entry union filter could be obstructed; dismantle and clean it.
Why is the group not heating up in my Brasilia Coffee Maker?
If the group on your Brasilia Coffee Maker isn't heating up even though the boiler is under pressure, it could be that air bleeding of the boiler did not occur during the water heating stage. When the machine is cold, check that the air vacuum valve is not blocked shut, and replace it if necessary. Also, the water heating circuit might be partially obstructed; check the group’s inlet and outlet pipes and unions, clean them, and replace if necessary. Remember to check the regeneration of the softener resins.
Why will my Brasilia EXECUTIVE Coffee Maker boiler not heat up?
If the boiler in your Brasilia Coffee Maker won't heat up, the heating element might be broken; replace it. Also, the heating element might not be receiving power; check and replace the related components. Finally, the safety thermostat, pressure switch, or main switch could be faulty; check and replace them if necessary.
Why is there water loss from the block ring-nut of my Brasilia EXECUTIVE Coffee Maker?
If you notice a loss of water from the block ring-nut during manual loading of your Brasilia Coffee Maker, the tap axis seal is likely defective. Replace it.
Why is there a loss between the group and the filter holder of my Brasilia EXECUTIVE?
If there is a loss between the group and the filter holder during delivery with your Brasilia Coffee Maker, the underpan seal is likely defective, or the edge of the filter is irregular. Replace the underpan seal.
Why is there a loss of water from the group valves locking in my Brasilia EXECUTIVE Coffee Maker?
If you experience a loss of water from the group valves locking in your Brasilia Coffee Maker, the seal is likely defective. Replace it.
Why is my Brasilia EXECUTIVE not dispensing hot water?
If your Brasilia Coffee Maker is not dispensing hot water, the supply tap might be off. Turn on the tap and check that the pipes are in the correct position. The dispensing channels could be clogged by scale, call a technician to do scale removal.
Why is coffee coming out from the sides of the filter holder on my Brasilia EXECUTIVE?
If coffee is coming out from the sides of the filter holder of your Brasilia Coffee Maker, there might be residues of dirt in the seat of the filter holder, preventing the coffee from passing through the nozzle. Clean it. The seal of the group might be worn out; replace it. The funnels might be clogged; clean or replace them.
General guidelines for correct coffee dispensing and ingredient handling.
Procedures for storing the machine when not in use for an extended period.
Instructions for safely turning off the machine after use.
Routine cleaning procedures to maintain machine hygiene and performance.
General| Brand | Brasilia |
|---|---|
| Model | EXECUTIVE |
| Category | Coffee Maker |
| Language | English |
To Next Page
