More information https://www.caravansplus.com.au
5)
Mount the
fridge
with the cabinet wall: the screw holder is built
in
the side wall of the
refrigerator,
a hole needs to be drilled
through
the screw holder into the side metal
panel
with a screw
(M5,
15mm
minimal)
and fix it on the
wall;
after
that,
use the screw cover to
cover the
hole.(If
the
refrigerator
needs to be drilled
through,
it should be confirmed before
leaving
the
factory.
The screws are not included with the
refrigerator.)
6)
Verify
the installation: once the installation had been
finished,
check the
continuity
of
the earth circuit and
carry
out all electrical
safety
testing
provided
for
by
current
regulations.
Protect and fix the cables in order to
prevent
accidental
pulling
of the cable from
disconnecting
it from the connections or
coming
into contact with hot
parts
with a
temperature
above
50°
C or with
sharp parts.
6. REMOVING
THE FREEZER
COMPARTMENT
Open
the lid and
pull
out the divider
horizontally.
Lid
Divide
(GH-1673
for
example)
7.
OPERATION OF BI-DIRECTIONAL FRIDGE DOOR
The
fridge
door
can
open Bi-Directionallywithoutthe
use
of
tools
to
change
the side
it
hinges
from.
(GH-1673
for
example)
From left to
right
From
right
to left
65
To Next Page
