Does the lift clear the vehicle body by a minimum 1" clearance (page 12 and page
25 - point 7)?
Do the parallel arms (bottom side) clear the doorsill when the lift is fully lowered (page
25 - point 3)?
Is the platform angle properly adjusted (pages 28 and 29), and is the floor level adjust-
ment correct (pages 30-32)?
When lowering and raising the platform:
See reverse side also
Installation Details Checklist
Is the base plate secured through the vehicle floor with eight bolts (pages 13-16)?
Are the underfloor reinforcement brackets installed as detailed on pages 9 and 13-16?
Are the ground cables, power cable and Circuit Sentry installed as detailed on pages
17-21?
Is the control box mounted to door as detailed and is the control box cable routed and
secured as detailed on pages 22 and 23? Note: Open and close door and function
lift through cycles to be certain the control box and cable clear the door and other
moving parts.
Have all decals been posted on the vehicle interior door panel next to the lift control
box (page 26)?
Have any necessary Quiet-Ride adjustments been made as outlined on pages 34 and
35?
Has the optional padding kit been installed (if applicable)?
Is the lift owner's (operator's) manual stored in the lift-mounted manual storage pouch
for the consumer?
Has The Braun Corporation Warranty/Registration card been filled out, processed and
mailed to The Braun Corporation?
✓
Lift Installation Checklist
May 2004
To Next Page
Loading...
