31
Shaver turns
off with fully
charged
battery.
Foil and cutter are worn
which requires more power
than the motor can deliver.
The appliance turns off.
– Renew Foil & Cutter cassette.
– Regularly oil the shaving system,
especially when cleaning with water
only.
Battery
segments in the
display are
skipped with
decreasing
battery
capacity.
Foil and cutter are worn
which requires more power
for each shave.
– Renew Foil & Cutter cassette.
– Regularly oil the shaving system,
especially when cleaning with water
only.
Shaving parts
have been
changed
recently but
replacement
symbol lights up.
Reset button has not been
pushed.
– Push the reset button for at least 3
seconds to reset the counter.
Shaver head is
damp.
1. Drying time after
automatic cleaning was
too short.
2. Drain of the Clean&Renew
station is clogged.
3. Cleaning cartridge has
been used for quite a
while.
1. Clean directly after shaving to allow
enough time for drying.
2. Clean the drain with a wooden
toothpick. Regularly wipe the tub
clean.
3. The ethanol/isopropanol proportion
has decreased while the oil
proportion has increased. Remove
residue with a cloth.
CLEAN&RENEW STATION
Cleaning does
not start when
pressing the
start button.
1. Shaver is not placed
properly in the
Clean&Renew station.
2. Cleaning cartridge
contains not enough
cleaning fluid (display
lights red).
3. Appliance is in stand-by
mode.
1. Insert shaver into the Clean&Renew
station (contacts of the shaver
need to align with contacts in the
station).
2. Insert new cleaning cartridge.
3. Press start button again.
Increased
consumption of
cleaning fluid.
Drain of the Clean&Renew
station is clogged.
– Clean the drain with a wooden
toothpick.
– Regularly wipe the tub clean.
92112397_7899cc7898cc7897cc_CN-KR-ANZ_S6-36.indd 3192112397_7899cc7898cc7897cc_CN-KR-ANZ_S6-36.indd 31 10.04.17 14:4510.04.17 14:45
CSS APPROVED Effective Date 21Apr2017 GMT - Printed 31Aug2017 Page 31 of 36
To Next Page
Loading...
