What to do if replacement symbol lights up after changing shaving parts on my Braun Electric Shaver?
If the replacement symbol lights up on your Braun Electric Shaver after you've recently changed the shaving parts, it means the reset button hasn't been pushed. Push the reset button for at least 3 seconds to reset the counter.
Why does my Braun Electric Shaver turn off with a fully charged battery?
If your Braun Electric Shaver turns off even with a fully charged battery, it's likely due to worn foil and cutter parts requiring more power than the motor can provide. Replacing the Foil & Cutter cassette should resolve this. Also, regularly oil the shaving system, especially after cleaning it with water only.
What to do if cleaning doesn't start when pressing the start button on my Braun 7CC-4 HUGO BOSS Electric Shaver?
If cleaning doesn't initiate when you press the start button, ensure the shaver is correctly placed in the Clean&Renew station so that the contacts align. Also, verify that the cleaning cartridge has enough cleaning fluid (replace it if the display lights red). Finally, ensure the appliance is not in stand-by mode by pressing the start button again.
Why has my Braun 7CC-4 HUGO BOSS's shaving performance dropped significantly?
A significant drop in shaving performance of your Braun Electric Shaver can be due to several reasons: worn foil and cutter, a changed personal setting, or a clogged shaving system. To resolve this, renew the Foil & Cutter cassette. For a thorough and fast shave we recommend the green (intensive) setting. Also, soak the Foil & Cutter cassette into hot water with a drop of dish liquid, rinse it properly, tap it out, and apply a drop of light machine oil on the foil once dry.
What to do if shaving performance dropped significantly on my Braun 7CC-4 HUGO BOSS?
A significant drop in shaving performance with your Braun Electric Shaver can be caused by several factors. First, the foil and cutter may be worn and need replacement. Second, check if the personal setting for shaving performance has been changed. For a thorough and fast shave, the green (intensive) setting is recommended. Third, the shaving system might be clogged. To resolve this, soak the Foil & Cutter cassette in hot water with a drop of dish liquid, then rinse it properly, tap it out, and apply a drop of light machine oil once it's dry.
Why does the replacement symbol light up on my Braun 7CC-4 HUGO BOSS even after changing shaving parts?
If the replacement symbol lights up on your Braun Electric Shaver after changing shaving parts, it may be because the reset button has not been pushed. Push the reset button for at least 3 seconds to reset the counter.
Why are battery segments skipped on my Braun 7CC-4 HUGO BOSS display?
Skipped battery segments on your Braun Electric Shaver display, while the battery capacity is decreasing, can happen if: * The foil and cutter are worn, requiring more power for each shave. In this case, renew the foil & cutter cassette. * The shaving system needs regular oiling, especially after cleaning with water only.
Why is there an increased consumption of cleaning fluid in my Braun Electric Shaver?
Increased consumption of cleaning fluid in your Braun Electric Shaver may be caused by a clogged drain in the Clean&Renew station. Clean the drain with a wooden toothpick and regularly wipe the tub clean.
What to do if the replacement symbol lights up after changing shaving parts on my Braun Electric Shaver?
If you've recently changed the shaving parts on your Braun Electric Shaver but the replacement symbol is still lit, it likely means the reset button hasn't been pressed. Push the reset button for at least 3 seconds to reset the counter.
What to do if shaving system is still wet after cleaning Program has been completed in Braun 7CC-4 HUGO BOSS Electric Shaver?
If the shaving system of your Braun Electric Shaver remains wet after the cleaning program, it could be due to a clogged drain in the Clean&Renew station or an old cleaning cartridge. Try cleaning the drain with a wooden toothpick and regularly wipe the tub clean. If that doesn't work, the ethanol proportion has decreased while the oil proportion has increased in the cleaning cartridge. Remove residue with a cloth.
General| Model | 7CC-4 HUGO BOSS |
|---|---|
| Charge Time | 1 hour |
| Wet & Dry Use | Yes |
| Cordless Use | Yes |
| Travel Case | Yes |
| Shaver Technology | Foil |
| Battery Type | Li-Ion |
| Run Time | 50 minutes |
| Quick Charge | 5 min |
To Next Page
