If you wish to change the temperature scale of your thermometer:
1. Make sure the thermometer is turned off.
2. Press and hold down the Power button . After about 3 seconds the display will show this sequence: ° C / SET / °
F / SET …
3. Release the Power button when the desired temperature scale is shown.
There will be a short beep to confirm the new setting, then the thermometer is turned off automatically
Care and cleaning
The probe tip is the most delicate part of the thermometer. It must be clean and intact to ensure accurate readings.
If the thermometer is ever accidentally used without a lens filter, clean the probe tip as follows:
Very gently wipe the surface with a cotton swab or soft cloth moistened with alcohol. After the alcohol has completely dried
out, you can put a new lens filter on and take a temperature measurement.
If the probe tip is damaged, please contact Consumer Relations.
Use a soft, dry cloth to clean the thermometer display and exterior. Do not use abrasive cleaners.
Never submerge this thermometer in water or any other liquid. Store thermometer and lens filters in a dry location free from
dust and contamination and away from direct sunlight
To Next Page
Loading...
