Page 33
UP
Lift Operating Instructions
To Load Passenger:
1. Load passenger onto platform
facing outward and lock wheel-
chair brakes.
Note: Outer barrier must be fully
unfolded (ramp position) until the
entire wheelchair has crossed the
roll stop. See Photos K and L.
2. Press red UP switch until platform
stops (reaches floor level). Re-
lease switch. See Photo S.
Switch Arm: Slide knob out to UP
position.
Note: Outer barrier must be UP
and barrier latch must be fully
engaged before raising platform.
Platform will raise above ground
level approximately three inches
before latch engages fully.
approximately 3˝
M N
P
O
To Next Page
Loading...
