38
Starting Intermittent Mode via Special Function Menu:
• Switch on pump with
sf and wait until self-check is finished.
• Insert disposable.
• Go to Special Functions Menu and select Intermittent Mode.
• Press
l to enter parameters and k to confirm.
After entering all desired parameters the pump can be started by pressing
sf
In the upper part of the display the icon for “Intermittent Mode” appears.
In bolus phase the screen shows the following:
After the bolus phase the pump switches to rate phase and the screen shows
the following:
Note: To cancel bolus infusion in the Intermittet Bolus therapy at any time it is
only possible with
sf.
Note: The delivery of drugs can be stopped and started again in the Intermittent
Mode at any time by pressing
sf. During infusion it is possible to change the
bolus volume, amount, VTBI as well as the time interval.
• Press
C.
• Use
t to navigate through the parameter list and select the parameter to
be changed with
l.
• Enter the new value and press
k.
The pump continues infusion.
Changing the bolus after start:
If the user edits the bolus the therapy progression changes.
• Press
C.
• Use
t to select Bolus and press l.
• Change Bolus by using
t and press k to confirm.
The pump automatically recalculates all other settings of the therapy.
The pump now delivers the
predefined bolus.
The pump now delivers the
predefined rate.
SPECIAL FUNCTIONS
Chapter 3
To Next Page
Loading...
Need help?
General