To Next PageTo Next PageWhat to do if my Braun Silk-expert 3 BD3001 is broken or appears defective?
If your Braun Epilator is broken, cracked, or appears defective, do not use it, especially if the power supply is damaged. Discontinue use immediately if you have any doubts about its safety or suspect damage.
How to fix a Braun Epilator when the power bars do not light up?
If the power bars on your Braun Epilator don't light up when the treatment window is placed on the skin, ensure the device is connected to an electrical outlet and in Ready mode. Also, make sure both skin tone sensors are in full contact with your skin. Try moving the device to ensure both sensors make proper skin contact.
Why is the first LED on my Braun Silk-expert 3 BD3001 flashing red?
If the first LED on the power bars of your Braun Epilator flashes red, it indicates that the removable treatment window reflector has been taken off. Replace the reflector to resolve this issue.
What to do if Braun Silk-expert 3 BD3001 doesn’t work on small areas?
If your Braun Epilator doesn’t work on small areas, ensure that both skin tone sensors are in contact with the skin. If the area is too small or curved, reposition the device so that both sensors make contact.
What does it mean if the power bars on my Braun Silk-expert 3 BD3001 Epilator show a red and white LED pattern?
If the power bars on your Braun Epilator display an unfamiliar pattern of one red LED shining along with individual white LEDs, it indicates a device error. Try removing and replacing the power supply connection. If the error persists, contact a Braun Service Centre for repair.
Why does only the first LED on my Braun Epilator illuminate red?
If only the first LED illuminates red on the power bar of your Braun Epilator, it means that the device has detected an invalid skin tone, indicating that your skin is either too light or too dark. For safety reasons, the device cannot be activated in this condition.
Why are all the white LEDs flashing on my Braun Silk-expert 3 BD3001 Epilator?
When all white LEDs on your Braun Epilator flash, it indicates that the product has reached the end of its lifetime and the maximum number of flashes (250,000) has been reached.
General| Model | BD3001 |
|---|---|
| Technology | Intense Pulsed Light (IPL) |
| Skin Tone Sensor | Yes |
| Power Source | Corded |
| Number of Intensity Levels | 3 |
| Treatment Window Size | 3 cm² |
| Skin Tone Adaptation | Yes |
| Corded/Cordless | Corded |
| Warranty | 2 years |
| Type | IPL |
| Treatment Areas | Body, Face |
| Flash Count | 100, 000 |
| Modes | Normal and Gentle |
| Energy Levels | 3-6 J/cm² |
Remove hair, clean, and dry the area before use.
Device reads skin tone to select appropriate light intensity for safety and efficacy.
Recommends testing on a small skin area first to check for reactions.
Fast treatment for large skin areas, using continuous flashing.
For small, sensitive areas, treating spot by spot.
Reduces light intensity for sensitive areas or beginners.
Ensure patch test, remove hair and cosmetics from the face.
Use Precision mode, close eyes, avoid treating the same area twice.
