6030
The thermometer includes a convenient night light to illuminate
the display in a dim environment.
The light will turn on when you press any button. It will stay on
until the thermometer is inactive for up to 15 seconds even after
temperature is taken.
This model stores the last 9 temperature measurements.
To display the stored measurement, the thermometer must
be turned on.
Press the Mem button.
The display shows the temperature, and when releasing the
Mem button, the stored temperature for that memory number
is displayed, together with “M”.
Each time the Mem button is pushed, the stored
reading and an M is displayed to indicate each
temperature measurement (eg. M2).
Memory mode is automatically exited by
not pressing the memory button for 5 seconds.
The last temperature taken is stored in its
memory and will be automatically displayed for 5
seconds when it is turned on again.
Your Braun ThermoScan
®
is shipped with the Celsius (° C) temperature scale activated. If you wish
to switch to Fahrenheit (° F) and/or back from Fahrenheit to Celsius, proceed as follows:
Make sure the thermometer is turned off.
Press and hold down the Power button
. After about 3 seconds
the display will show this sequence: ° C / SET / ° F / SET ...
1
2
Care and cleaning
The probe tip is the most delicate part of the thermometer.
It must be clean and intact to ensure accurate readings.
If the thermometer is ever accidentally used without a lens filter,
clean the probe tip as follows:
Verygentlywipethesurfacewithacottonswaborsoftcloth
moistened with alcohol. After the alcohol has completely dried
out, you can put a new lens filter on and take a temperature
measurement.
If the probe tip is damaged, please contact the local service center.
Use a soft, dry cloth to clean the thermometer display and exterior. Do not use abrasive
cleaners. Never submerge this thermometer in water or any other liquid. Store thermometer
and lens filters in a dry location free from dust and contamination and away from direct
sunlight.
Additional lens filters (LF 40) are available at most stores carrying Braun ThermoScan
®
.
Replacing the batteries
Thethermometerissuppliedwithtwo1.5VtypeAA(LR06)
batteries. For best performance, we recommend Duracell
®
alkaline batteries.
Insert new batteries when the battery symbol appears
on the display.
Open the battery compartment. Remove the batteries and replace
with new batteries, making sure the poles are in the right direction.
Snap battery door into place.
1
2
3
Only discard empty batteries. To protect the environment, dispose of empty
batteries at your retail store or at appropriate collection sites according to
national or local regulations.
Calibration
The thermometer is initially calibrated at the time of manufacture. If this
thermometer is used according to the use instructions, periodic re-adjustment is
not required. If at any time you question the accuracy of the temperature
measurement, please contact your authorized service center.
Manufacturing date is given by the LOT number located in the battery compartment.
The first three (3) digits after LOT represent the Julian date that the product was manufactured
and the next two (2) digits represent the last two numbers of the calendar year the product was
manufactured. The last identifiers are the letters that represent the manufacturer.
An example: LOT 11614K, this product has been manufactured on the 116th day of the year 2014.
Release the Power button when the desired temperature scale is shown.
There will be a short beep to confirm the new setting, then the thermometer is
turned off automatically.
3
Changing the temperature scale
Changing the temperature scale
Changing the temperature scale
To Next Page
Loading...
