What to do if the Braun ThermoScan IRT 6030 displays a system error?
If the Braun Thermometer displays a continuous flashing self-check and doesn't beep or show the ready symbol, allow it to turn off automatically (about 1 minute), then turn it back on. If the error continues, remove the batteries and reinsert them to reset the device. If the problem persists after these steps, further assistance is needed.
What to do if the Braun ThermoScan IRT 6030 Thermometer says battery is too low?
If your Braun Thermometer indicates that the battery is too low for accurate temperature readings, replace the batteries with new ones.
What to do if Braun Thermometer displays system error?
If your Braun thermometer shows a continuous flashing self-check display without the ready beep or symbol, wait one minute for the thermometer to turn off automatically, then turn it on again. If that doesn't work, reset the thermometer by removing the batteries and putting them back in.
Why does my Braun Thermometer show temperature out of range?
If your Braun Thermometer shows a temperature outside the typical human range (34 – 42.2 °C or 93.2 – 108 °F), ensure the probe tip and lens are clean, and a new, clean lens filter is attached. Also, confirm the thermometer is properly inserted. Then, take another measurement.
What to do if Braun ThermoScan IRT 6030 Thermometer gives inaccurate measurement?
To resolve inaccurate measurements with your Braun Thermometer, replace the lens filter, reposition the thermometer, and press the Start button to begin a new measurement.
How to fix Braun ThermoScan IRT 6030 ambient temperature error?
If your Braun thermometer shows an ambient temperature error, allow the thermometer to remain for 30 minutes in a room where the temperature is between 50 and 104 °F or 10 and 40 °C.
General| Brand | Braun |
|---|---|
| Model | ThermoScan IRT 6030 |
| Category | Thermometer |
| Language | English |
To Next Page
