5
English
4
Fit the probe snuggly into the ear canal, then
push and release the Start button .
ExacTemp light will pulse while temperature is in progress. The light will
remain solid for 3 seconds to indicate that a successful temperature
reading has been achieved.
NOTE: If the probe has been properly inserted into the ear canal
during the measurement, a long beep will sound to signal the
completed measurement.
If the probe has NOT been constantly placed in a stable position in the
ear canal, a sequence of short beeps will sound, the ExacTemp light
will go out and the display will show an error message (POS = position
error).
See
«
Errors and troubleshooting
»
section for more
information.
5
6
9
6030
The confirmation beep indicates that an accurate temperature measurement has been
taken. The result is shown on the display.
Temperature displays.
For the next measurement, press Eject button
to remove and discard used lens filter, and put on
a new, clean lens filter.
The Braun ThermoScan Infrared Ear Thermometer
turns off automatically after 60 seconds of inactivity.
The thermometer can also be turned off by
pressing the Power button .
The display will briefly flash OFF and it will
go blank.
7
Temperature taking hints
Always replace disposable lens filters to maintain accuracy and hygiene. The right ear
measurement may differ from the measurement taken in the left ear. Therefore, always take the
temperature in the same ear. The ear must be free from obstructions or excess earwax build-up
to take an accurate reading.
To Next Page
Loading...
