4
1
How to use
Remove the thermometer from the protective case.
2
Push the Power button .
During an internal self-check, the display shows all segments. Then the last
temperature taken will be displayed for 5 seconds.
1. Guyton A C, Textbook of medical physiology, W.B. Saunders, Philadelphia, 1996, p 919
2. Guyton A C, Textbook of medical physiology, W.B. Saunders, Philadelphia, 1996, p 754-5
3. Netter H F, Atlas of Human Anatomy, Novartis Medical Education, East Hanover, NJ, 1997, pp 63, 95.
3
The lens filter indicator will blink to signal one is
needed.
To achieve accurate measurements, make sure
a new, clean lens filter is in place before each
measurement.
Attach a new lens filter by pushing the
thermometer probe straight into the lens filter
inside the box and then pulling out.
Note: The thermometer will not work unless a lens
filter is attached.
To Next Page
Loading...
