Page 52
4500
Cycles
Inspect lifting arm bushings and pivot
pins for visible wear or damage
Inspect outer barrier pivot pin mounting
bolts (2)
Mounting
Decals and Antiskid
Replace if needed.
Tighten or replace if needed
Check to see that the lift is securely anchored to
the vehicle and there are no loose bolts, broken
welds, or stress fractures.
Replace decals if worn, missing or illegible. Re-
place antiskid if worn or missing. See Decals and
Antiskid section.
Repeat all previously listed inspection, lubrica-
tion and maintenance procedures at 750 cycle
intervals.
Consecutive
750 Cycle
Intervals
Maintenance and Lubrication Schedule
To Next Page
Loading...
