BRAYER BR1104 - Page 10

10 EN
(15) « » counterclockwise to release some
steam. After that close the steam supply by turning
the knob (15) « » clockwise until bumping
«•». Switch the steam supply o󰀨 by pressing the
steam supply button (10) « » and switch the
co󰀨ee maker o󰀨.
• Wait until the co󰀨ee maker cools down and remove
the tip (17) from the cappuccinator pipe (16), wipe
the outer side of the cappuccinator pipe (16) with a
soft damp cloth and wash the tip (11) under a water
jet.
• Note: Successive making of co󰀨ee should be
performed with an at least 5 min interval.
WARMING THE DRINKS
• You can warm up your drinks by putting the
cappuccinator pipe (16) without the tip (17) into the
cup with the drink.
• Press the steam supply button (10) « », wait until
the indicator (9) « » lights up.
• Put the cappuccinator pipe (16) without the tip (17)
into the cup with the drink
• you want to warm up. Carefully turn the steam supply
control knob (15) « » counterclockwise.
• Close the steam supply by turning the knob (15) «
» clockwise until bumping «•».
• Switch the steam supply o󰀨 by pressing the steam
supply button (10) « » again.
• Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨
button (11) «
», the indicator (7) « » will go out.
• Note: some water or steam may appear from the
lter holder (5), it is normal.
REMOVING MINERAL SCALE
For e󰀨ective operation of the co󰀨ee maker we
recommend removing scale every 2-3 months and when
using “hard” water more often.
1. Make sure that all the control buttons (10, 11, 12)
are in the o󰀨 position.
2. Make sure that the steam supply is closed. To do
this turn the knob (15) «
» clockwise until
bumping «•».
3. Make citric acid solution: 2 teaspoons of acid to 1
litre of water and pour the solution into the water
tank (20). Install the tank (20) back to its place.
4. Install the co󰀨ee lter (6) into the holder (5) having
preliminary matched the ledge on the lter (6) with
the groove on the holder (5) and turn the lter (6)
counter/clockwise to x the lter. Do not put ground
co󰀨ee into the lter (6).
5. Install the lter holder (5) into the co󰀨ee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the lter holder handle
(4) to the right until bumping «
».
6. Place a suitable cup on the grid (2).
7. Insert the power plug into the mains socket.
8. Switch the co󰀨ee maker on by pressing the on/
o󰀨 button (10) «
», the indicator (7) « » will
light up.