BRAYER BR1104 - Making Espresso

8 EN
• Install the lter holder (5) into the co󰀨ee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the lter holder handle
(4) to the right until bumping « ».
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
• Switch the co󰀨ee maker on by pressing the on/o󰀨
button (11) «
», the indicator (7) « » will light up.
• Wait until the indicator (8) « » lights up, then
switch the water supply on by pressing the button
(12) « ». After 15-20 seconds press the button
(12) « » again to switch the water supply o󰀨 and
pour the water out of the cup.
• Preheating is over.
MAKING ESPRESSO
• Put ground co󰀨ee in the lter (6), slightly tamp the
ground co󰀨ee with the back side of the measuring
spoon (21).
• Install the lter holder (5) into the co󰀨ee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the lter holder handle (4)
to the right until bumping « ».
• Wait until the indicator (8) « » lights up, the co󰀨ee
maker is ready for making co󰀨ee.
• Switch the water supply on by pressing the button (12)
« », watch the cup lling with the ready co󰀨ee,
press the button (12) « » again to switch the water
supply o󰀨.
• Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨
button (11) «
», the indicator (7) « » will go out.
• Wait until the co󰀨ee maker cools down and remove
the lter holder (5) by turning the handle (4) to the left
« ». Remove the ground co󰀨ee remnants and wash
the lter (6).
• For easy removing of the co󰀨ee remnants use the
retainer on the handle (4) to prevent the lter (6) from
falling o󰀨 the holder (5).
• Notes:
- The cups should be preliminary heated up, when
water heats up in the boiler, put the cups on the
tray (14).
- If you need to promptly remove the lter holder
(5), you have to reduce the pressure in the boiler,
switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨
button (11) «
», place a suitable cup under the tip
ATTENTION!
When making co󰀨ee do not leave the operating
co󰀨ee maker unattended, as it is necessary to watch
the cup being lled with ready co󰀨ee!
AFTER PREHEATING:
• Make sure that the control buttons (10, 12) are in the
o󰀨 position.
• Make sure that the steam supply is closed. To do this
turn the knob (15) «
» clockwise until bumping
«•».
• Remove the lter holder (5) by turning the handle (4)
to the left « » and remove the lter holder (5).