BRAYER BR1104 - Cleaning the Coffee Maker

11EN
9. Press the button (12) « » and ll a cup of about
100 ml capacity with water (it is necessary to drain
the water from the boiler and ll the boiler with the
citric acid solution), switch the water supply o󰀨 by
pressing the button (12) « » again.
10. Wait until the indicator (8) « » lights up, then
switch the water supply on by pressing the button
(12) « » and ll a cup of about 100 ml capacity,
press the button (12) « » again to switch the
water supply o󰀨 and pour the liquid out of the cup.
11. After a while repeat the procedure described in
the paragraph 10 and ll the cup of about 100 ml
capacity again.
12. Press the steam supply button (10) « », wait
until the indicator (9) « » lights up. Put a suitable
bowl under the tip (17) and slightly open the
steam supply by turning the knob (15) « »
counterclockwise. Carefully turn the knob (15) «
» to the maximal steam release position,
release the steam for about 1 minute, then close
the steam by turning the knob (15) « »
clockwise until bumping «•» and switch the steam
supply o󰀨 by pressing the button (10) « ».
13. Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨
button (11) «
». Wait for 10-15 minutes.
14. Perform the steps 10 and 11 at least 3 times.
15. Repeat the cleaning procedure for the steam
release channels described in the paragraph 12.
16. With small intervals, repeat the boiler cleaning
procedure (paragraph 10) until the citric acid
solution dissolves in the tank (20) completely.
17. Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨
button (11) « ».
18. Fill the water tank (20) with clear water until
maximal level and repeat the steps 10, 12 at least 3
times without the 10-15 minute break.
19. Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨
button (11) «
».
• Note: to remove the scale you can use special
descaling agents for co󰀨ee makers and co󰀨ee
machines, strictly following the instructions on their
usage.
CLEANING THE COFFEE MAKER
• If there is ground co󰀨ee scale remainin in the lter (6)
openings, clean the lter (6) with a small brush.
• Wipe the co󰀨ee maker body with a soft, slightly damp
cloth and then wipe the co󰀨ee maker body (18)
dry. Do not use abrasives and solvents to clean the
co󰀨ee maker body.
• Do not immerse the co󰀨ee maker body (18), the
power cord and the power plug into water or any
other liquids.
• Wash the removable parts of the co󰀨ee maker with
warm water and neutral detergent, then rinse them
and dry.