EasyManua.ls Logo

BRAYER BR1104 - Auto Switch off Function

BRAYER BR1104
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7EN
Insert the power plug into the mains socket.
Switch the co󰀨ee maker on by pressing the on/o󰀨
button (11) «
», the indicator (7) « » will light up.
To ll the boiler with water press the button (12) «
», wait for 15-20 seconds, or at the rst signs
of appearance of water in the cup, switch the water
supply o󰀨 by pressing the button (12) « » again.
Wait until the indicator lights up, then switch the
water supply on by pressing the button (12) « ».
After the cup is lled with water, press the button (12)
« » again to switch the water supply o󰀨 and pour
the water out of the cup.
Depending on the cup capacity repeat this procedure
several times until the boiler is clean.
HOW TO MAKE A GOOD ESPRESSO
Use ground co󰀨ee for espresso co󰀨ee makers.
Slightly tamp the ground co󰀨ee in the lter (6), you
can do it with the back side of the measuring spoon
(17).
Co󰀨ee strength depends on the quality and grinding
degree of co󰀨ee beans. If co󰀨ee is pouring out too
long, this means the co󰀨ee powder is too ne or it is
tamped too strongly.
THERMOMETER
You can control the temperature by the indicators (8, 9)
and with the built-in thermometer (13). The thermometer
(13) scale shows the water temperature in the co󰀨ee
maker.
PREHEATING
To make a cup of hot espresso, it is recommended to
preliminary heat up the co󰀨ee lter (6) and the lter
holder (5).
Open the lid (19) and ll the tank (20) with water, or
remove the tank (20) and ll it with water, then install
the tank (20) back to its place.
Install the co󰀨ee lter (6) into the holder (5) having
preliminary matched the ledge on the lter (6) with
the groove on the holder (5) and turn the lter (6)
counter/clockwise to x the lter.
ATTENTION!
Do not remove the lter holder (5) when the
buttons (10, 12) are pressed.
Do not remove the lter holder (5) immediately
after preparing co󰀨ee as there is redundant water
and steam pressure inside the lter (5), let the
co󰀨ee maker cool down completely.
To remove the lter holder (5) turn the handle (4)
to the left «
» and remove the lter holder (5).
AUTO SWITCH OFF FUNCTION
If no actions were performed during 25 minutes
after switching on, the co󰀨ee maker will switch o󰀨
automatically.

Related product manuals