BRAYER BR1113 - Cleaning the Coffee Maker; Troubleshooting

13
EN
Note: to remove the scale you can use special
descaling agents for co󰀨ee makers and co󰀨ee
machines, strictly following the instructions on their
usage.
CLEANING THE COFFEE MAKER
• If there is ground co󰀨ee scale remainin in the lter (5)
openings, clean the lter (5) with a small brush.
• Wipe the co󰀨ee maker body with a soft, slightly
damp cloth and then wipe the co󰀨ee maker body (11)
dry. Do not use abrasives and solvents to clean the
co󰀨ee maker body.
• Do not immerse the co󰀨ee maker body (11), the
power cord and the power plug into water or any
other liquids.
• Wash the removable parts of the co󰀨ee maker with
warm water and neutral detergent, then rinse them
and dry.
DRIP TRAY (1)
• A red pop-up indicator (3) in the grid (2) will show
when the tray (1) is full.
• Remove the grid (2) from the tray (1), remove the
tray (1) and pour out water, install the tray back to its
place, put the grid (2) on the tray (1).
• If necessary, wash the tray (1) and the grid (2) with
water and soft detergent, rinse and dry.
TROUBLESHOOTING
Problem Cause Solution
Water leaks from
the bottom of the
co󰀨ee maker
The tray is full of
water.
Please, clean the tray.
The co󰀨ee
maker is
damaged.
Please, apply to the service
center for repairing the
co󰀨ee maker.
Water leaks from
the lter holder.
There is ground
co󰀨ee on the
lter.
Clean the lter edges from
ground co󰀨ee.
Ready co󰀨ee
has unpleasant
taste.
The co󰀨ee
maker was not
washed after
descaling.
Clean the co󰀨ee maker
from mineral scale and
wash it from the remaining
descaling agent.
Ground co󰀨ee
was stored in a
humid place for
a long time.
Please, use fresh ground
co󰀨ee. Keep unused
ground co󰀨ee in a hermetic
package in a dry cool place.
The unit cannot
be switched on
No voltage in the
mains socket.
The power plug
is not completely
inserted into the
socket.
Make sure that the mains
socket is properly operating.
Check whether the power
plug is completely inserted
into the socket.
Steam doesn’t
froth milk
The steam ready
indicator is
ashing..
You can use steam to froth
milk only after the indicator
starts glowing white.
The used cup
does not suit
for proper milk
frothing.
Use a tall and narrow cup.
You used
skimmed milk.
Use only whole milk with fat
content 4-6%.