BRAYER BR1113 - Auto Switch off Function

8
EN
cup is lled with water, press the button (15) «
» again to switch the water supply o󰀨 and pour the
water out of the cup.
• Notes: - when you switch the water supply on for the
rst time, some foreign noise of the operating pump
is possible, since air comes out of the boiler, after a
while the noise will disappear.
• Wait until the button (15) indicator stops ashing and
glows constantly, then switch the water supply on
by pressing the button (15) «
». After the cup is
lled with water, press the button (15) «
» again
to switch the water supply o󰀨 and pour the water out
of the cup.
• Depending on the cup capacity repeat this procedure
several times until the boiler is clean.
ATTENTION!
• Do not remove the lter holder (4) during co󰀨ee
making.
• Do not remove the lter holder (4) immediately after
preparing co󰀨ee as there is redundant water and
steam pressure inside the lter (4), let the co󰀨ee
maker cool down completely.
• To remove the lter holder (4) turn the handle (3) to
the left «Insert» and remove the lter holder (4).
AUTO SWITCH OFF FUNCTION
• If no actions were performed during 25 minutes
after switching on, the co󰀨ee maker will switch o󰀨
automatically.
HOW TO MAKE A GOOD ESPRESSO
• Use ground co󰀨ee for espresso co󰀨ee makers.
• Slightly tamp the ground co󰀨ee in the lter (5), you
can do it with the back side of the measuring spoon
(17 ).
• Co󰀨ee strength depends on the quality and grinding
degree of co󰀨ee beans. If co󰀨ee is pouring out too
long, this means the co󰀨ee powder is too ne or it is
tamped too strongly.
PREHEATING
• To make a cup of hot espresso, it is recommended to
preliminary heat up the co󰀨ee lter (5) and the lter
holder (4).
• Open the lid (18) and ll the tank (19) with water, or
remove the tank (19) and ll it with water, then install
the tank (19) back to its place.
• Insert the lter (5) into the holder (4).
• Install the lter holder (4) into the co󰀨ee maker. The
holder (4) ledges should match the grooves on the
boiler «Insert», after that turn the lter holder handle
(3) to the right until bumping «Lock».
• Place a suitable cup on the grid (2).
• Make sure that the steam supply is closed. To do this
turn the knob (8) « » clockwise until bumping «•».
• Insert the power plug into the mains socket.
• Switch the co󰀨ee maker on by pressing the on/o󰀨
button (14) « », the button (14) indicator will
light up.