BRAYER BR1113 - Making Espresso

9
EN
• Wait until the button (15) indicator stops ashing and
glows constantly, then switch the water supply on by
pressing the button (15) «
», after 15-20 seconds,
press the button (15) «
» again to switch the water
supply o󰀨, drain water from a cup.
• Preheating is over.
MAKING ESPRESSO
ATTENTION! When making co󰀨ee do not leave the
operating co󰀨ee maker unattended, as it is necessary to
watch the cup being lled with ready co󰀨ee!
AFTER PREHEATING:
• Make sure that the steam supply is closed. To do this
turn the knob (8) «
» clockwise until bumping
«●».
• Remove the lter holder (5) by turning the handle (3)
to the left «Insert» and remove the lter holder (5).
• Put ground co󰀨ee in the lter (5), slightly tamp the
ground co󰀨ee with the back side of the measuring
spoon (17).
• Install the lter holder (4) into the co󰀨ee maker. The
holder (4) ledges should match the grooves on the
boiler «Insert», after that turn the lter holder handle
(3) to the right until bumping «Lock».
• Wait until the indicator (11) lights up, the co󰀨ee
maker is ready for making co󰀨ee.
• Switch the water supply on by pressing the button
(15) «
», watch the cup lling with the ready
co󰀨ee, press the button (15) «
» again to switch the
water supply o󰀨.
Notes:
- when you press the button (15) «
», the pump
will switch on for 3 seconds to pre-wet the ground
co󰀨ee in the lter (5), after a three-second pause,
the pump will switch on and will work until it is
switched o󰀨 by pressing the button (15) «
»
again;
- the pump operation time is limited to 60 seconds,
if during this time the cup is not lled with ready
co󰀨ee, switch the water supply on again by
pressing the button (15) «
».
• Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨
button (14) « », the button (16) indicator will
go out.
• Wait until the co󰀨ee maker cools down and remove
the lter holder (5) by turning the handle (4) to the left
«Inser». Remove the ground co󰀨ee remnants and
wash the lter (6).
• For easy removing of the co󰀨ee remnants use the
retainer on the handle (3) to prevent the lter (5) from
falling o󰀨 the holder (4).
Notes:
- the cups should be preliminary heated up, when
water heats up in the boiler, put the cups on the
tray (7).