Why can't I display weight in my desired unit on Brecknell Scales?
This issue occurs when the desired unit is not enabled, or d?5oz when the unit is lb:oz. To resolve this, enable the unit in CONFG-UNITS.
What does 'PWT.ER' mean on Brecknell Scales?
The 'PWT.ER' error means the piece weight is too small (less than 0.5d), indicating that the weight on the platform is insufficient to define a valid reference weight. Use a greater weight for the sample.
What does 'PCT.ER' mean on my Brecknell Scales?
The 'PCT.ER' error means the unit-percentage weight is too small. Specifically, the weight of 1%, 0.1%, or 0.01% (determined by CONFG-FUNC-PERCNT) is less than 0.5d. To resolve this, use more weight for the sample.
What does 'STB.ER' mean on Brecknell Scales?
The 'STB.ER' error indicates that USER-HOLD-STB.TIM is too short, USER-HOLD-HLD.RG is too small, or there is another failure. Try setting USER-HOLD-STB.TIM longer or setting USER-HOLD-HLD.RG bigger.
Provides operational warnings, maintenance safety, and cleaning guidelines.
Describes the scale's ports for power, USB, RS-232, and display.
Covers analog circuitry, capacity, accuracy, and calibration methods.
Describes front panel layout, display, and key operations.
Detailed configuration settings for CONFG and USER menus.
Steps to enter calibration, perform zero and linearity calibration.
Overview of commands and various communication protocols.
Provides causes and remedies for common error messages.
To Next Page
General