Why are my Brecknell MBS-150 Scales giving an incorrect weight reading?
An incorrect weight reading from your Brecknell Scales may be due to the balance not being set to zero or not being calibrated. Press the Tare button to zero the balance. If that doesn't work, calibrate the balance.
What to do if my Brecknell MBS-150 show Err 1?
The Err 1 message on your Brecknell Scales indicates an overweight error, meaning the sample being weighed is too heavy. Remove some of the sample. If the sample is within the balance capacity, the balance may need to be calibrated.
How to fix a Brecknell MBS-150 with no display?
If your Brecknell Scales have no display, the power adapter may not be properly connected, or the batteries may be dead. Reconnect the power adapter or replace the batteries.
What does Err 0 mean on Brecknell MBS-150?
Err 0 on Brecknell Scales typically means the platform is too light. Make sure the stainless steel cover is properly in place. Turn the scale off, remove the platform, and then replace it before reapplying power. If the error continues, the weight sensor or circuit board may be faulty, and you should contact your distributor.
What to do if my Brecknell Scales display Err 3?
The Err 3 error on Brecknell Scales indicates there was weight on the balance during power up. Remove any weight from the platform, then turn the balance off and back on.
What does Err 2 mean on Brecknell MBS-150 Scales?
Err 2 on Brecknell Scales indicates an underweight error, similar to Err 0, suggesting the platform isn't properly installed. Power off the balance and re-seat the platform before reapplying power. The balance may need to be calibrated.
What does F1 AZT mean on Brecknell MBS-150?
The error code F1 AZT on Brecknell Scales means a button was pressed during power up. Turn the balance off and back on again.
What does F2 Cnt mean on Brecknell MBS-150?
The error code F2 Cnt on Brecknell Scales means a button was pressed during power up. Turn the balance off and back on again.
To Next Page
General
