Breitling Aerospace Evo - Rider-Tab Bezel

48
3.4 USING THE ALARM FUNCTION
Select the AL (alarm) function.
Pull the crown out: the digits will flash.
Display the desired alarm time by rotating the crown for-
ward or backward (rapid rotation changes the hour read -
out, slow rotation changes the minute readout).
Push the crown back in. AL appears, confirming that the
alarm function is running.
When the alarm sounds, press on the crown to end the
buzzing.
ME Aerospace Evo 16.04.13 11:54 Page48
1
1
1
1
C064 Aerospace Evo - Breitling - 264p_2rbt_Breitling - FB 003 - Recto - 3
C064 Aerospace Evo - Breitling - 264p_2rbt_Breitling - FB 003 - Recto - 3
Data sortie: 14.01.2015 - 08:35:09 - BlackData sortie: 14.01.2015 - 08:35:09 - Magenta
C064 Aerospace Evo - Breitling - 264p_2rbt_Breitling - FB 003 - Recto - 3
Plate Control Strip
© Heidelberger Druckmaschinen AG 2013
V15.0i (pdf)
Topsetter
Agfa
Azura TS
4/22
0.5 P
Times
1 P
Times
2 P
Times
4 P
Times
Times
4P
Times
2P
Times
1P
Times
0.5P
0/100% 1% 2% 3% 5% 10% 20% 25% 30% 40% 50% 60% 70% 75% 80% 90% 95% 97% 98% 99%
Lin+
Process
To set or reset the alarm, press on the crown after selecting the AL (alarm)
function.
AL displayed: alarm on.
OF displayed: alarm off.
To test the alarm function, press on the crown during more
than two seconds after selecting the AL (alarm) function:
the buzzer will sound.
Note: remember to take into account the watch’s time mode (2x12H or 24H)
when setting the alarm to the desired time (see 2.1).
49
ME Aerospace Evo 16.04.13 11:54 Page49
1
1
1
1
C064 Aerospace Evo - Breitling - 264p_2rbt_Breitling - FB 003 - Recto - 3
C064 Aerospace Evo - Breitling - 264p_2rbt_Breitling - FB 003 - Recto - 3
Data sortie: 14.01.2015 - 08:35:09 - BlackData sortie: 14.01.2015 - 08:35:09 - Magenta
C064 Aerospace Evo - Breitling - 264p_2rbt_Breitling - FB 003 - Recto - 3
Plate Control Strip
© Heidelberger Druckmaschinen AG 2013
V15.0i (pdf)
Topsetter
Agfa
Azura TS
4/22
0.5 P
Times
1 P
Times
2 P
Times
4 P
Times
Times
4P
Times
2P
Times
1P
Times
0.5P
0/100% 1% 2% 3% 5% 10% 20% 25% 30% 40% 50% 60% 70% 75% 80% 90% 95% 97% 98% 99%
Lin+
Process