BREN Razor 700 Series User Manual

BREN 700-Series User Manual
Installation
2-5
Step 6
Insert the roll holder support with the screws into the holes of the stand, and then tighten them
up as shown in Figure 2.2-7. You could decide roll holder support’s position by inserting into
different holes.
Step 7
Place the roll holder 1 onto the roll holder support (Figure 2.2-8).
3 screws
Figure 2.2-7
Roll holder support
Roll holder 1
Figure 2.2-8
Roll holder support
Roll holder 2

BREN Razor 700 Series Specifications

General

Brand	BREN
Model	Razor 700 Series
Category	Cutter
Language	English