24
4.3.10 RAIN
The RAINFALL section shows the rainfall or rain rate information.
4.3.10.1 THE RAINFALL DISPLAY MODE
Press [ RAIN ] key to toggle between:
1. RATE - Current rainfall rate (base on 10 min rain data)
2. HOURLY - the total rainfall in the past hour
3. DAILY - the total rainfall from midnight (default)
4. WEEKLY - the total rainfall of the current week
5. MONTHLY- the total rainfall of the current calendar
month
6. TOTAL - the total rainfall since the last reset
Rainfall period
4.3.10.2 TO RESET THE TOTAL RAINFALL RECORD
In normal mode, press and hold [ RAIN ] key for 2 seconds to reset all the rainfall record.
NOTE:
Erroneous readings may occur during the installation of the 7-in-1 sensor array. Once the
installation is completed and functioning correctly, it’s advisable to clear all the data and start
afresh.
4.3.11 LIGHT INTENSITY, UV INDEX & SUNBURN TIME
This section of display show the sunlight intensity, UV index and sunburn time.
4.3.11.1 SOLAR LIGHT INTENSITY & SUNBURN TIME MODE:
During solar light intensity mode, press
[ SUN ] key to switch between sunlight
intensity and sunburn time.
Solar light intensity mode Sunburn time mode
UV INDEX VS SUNBURN TIME TABLE
Exposure level Low Moderate High Very high Extreme
UV index 1 2 3 4 5 6 7 8 9 10 11 12~16
Sunburn time N/A 45 minutes 30 minutes 15 minutes 10 minutes
Recommended
protection
N/A
Moderate or high UV level! Suggest to
wear sunglasses, broad brim hat and
long-sleeved clothing.
Very high or Extreme UV level! Suggest
to wear sunglasses, broad brim hat and
long-sleeved clothing, If you have to stay
outdoors, make sure to seek shade.
NOTE:
- The sunburn time is based on normal skin type, it is just a reference of UV strength. In general, the darker
one's skin is, the longer (or more radiation) it takes to aect the skin.
- The light intensity function is for sunlight detection.
To Next Page
Loading...
Need help?
General
