Bresser 4Cast XL WIFI User Manual

36
8.1.1 FIRMWARE UPDATE STEP
1. Download the latest version rmware to your PC/Mac.
2. Set the console into AP (access point) mode then connect the PC/Mac to the console (refer
to section 6.1 and 6.2).
3. From the SETUP page, press ADVANCED to enter advance setting
4. Under the rmware upload section, press
Browse
to locate the rmware le saved on
your PC/Mac.
5. Press
Upload
to start rmware update.
The update time is around 5 ~ 10 minutes. While updating, the
progress will be displayed (i.e. 100 is completion).
6. The console will restart once the update is completed.
7. The console will stay in AP mode for you to check the rmware version and all the current
setting. Simply press and hold [ SENSOR / WI-FI ] key for 6 seconds to exit AP mode.
IMPORTANT NOTE:
- Please keep connecting the power during the rmware update process.
- Please make sure your PC/Mac's WI-FI connection is stable.
- When the update process start, do not operate the PC/Mac and console until the update nished.
- During rmware update the console will stop upload data to the cloud server. It will reconnect to your WI-
FI router and upload the data again once the rmware update succeed. If the console cannot connect to
your router, please enter the SETUP page to setup again.
- After the rmware update, If the setup informations are missing, please input the setup information again.
- Firmware update process have potential risk, which cannot guarantee 100% success. If the update fail,
please redo the above step to update again.
8.2 BATTERY REPLACEMENT
When low battery indicator
or is
displayed near the antenna icon of
the sensor(s), it indicates that the
outdoor 7-IN-1 sensor and/or current
channel sensor(s) battery power is
low respectively. Please replace with
new batteries.
8.2.1 RE-PAIRING THE SENSOR(S) MANUALLY
Whenever you changed the batteries of the 7-in-1 weather sensor array or other additional
sensors, re-synchronization must be done manually.
1. Change all the batteries to new ones in the low battery sensor(s).
2. Press [ SENSOR / WI-FI ] key on the console to enter sensor synchronization mode (as
indicated by the ashing antenna
).
8.3 RESET AND FACTORY RESET
To reset the console and start again, press the [ RESET ] key once or remove the backup
battery and then unplug the adapter.
To resume factory settings and remove all data, press and hold the [ RESET ] key for 6
seconds.

Bresser 4Cast XL WIFI Specifications

General

Brand	Bresser
Model	4Cast XL WIFI
Category	Weather Station
Language	English