34
Troubleshooting Milk Froth Preparation
Milk steam cycle does not start
- Check if the water tank is correctly positioned, if empty, fill with potable
water.
- Check steam tip for any blockages and ensure wand is lowered.
Quality of froth not up to standard
- Be sure to use whole or semi-skimmed milk at refrigerated temperature
(about 4-6 °C / 39-43 F). For a better result, the milk must be newly
opened.
- Check the milk froth setting.
- Use the Breville milk jug provided.
- Clean both the milk jug and steam wand after each use.
- Clean the steam wand. Navigate to Maintenance menu.
- Select Clean Steam Wand and follow the on-screen prompts.
Steam is very wet
- Use cold, potable water. Do not use highly filtered, demineralised or
distilled water.
Milk overflows
- Fill jug with appropriate milk volume.
- Minimum fill level as marked on the inside & outside of the jug.
- Maximum fill level as marked on the inside & outside of the jug.
- To stop overflow, either reduce the initial volume of milk and/or reduce the
froth level. This varies depending on milk type.
Milk temperature is too hot
- Be sure to use the Breville milk jug provided.
- Check the milk jug is positioned correctly on the milk jug temperature
sensor.
- Decrease the milk temperature setting.
Milk temperature is not hot enough
- Preheat cup.
- Use the Breville milk jug provided.
- Check the milk jug is positioned on the milk jug temperature sensor.
- Increase the milk temperature setting.
- Check the steam tip for blockages.
Lower Wand alert is displayed
- Ensure the steam wand is lowered.
Clean Steam Wand alert is displayed
- Clean the Steam Wand. - Navigate to Maintenance menu. Select Clean Steam Wand and follow the
on-screen prompts.
To Next Page
Loading...
