33
5) Activate the Brigade Backsense
®
System (ensure the vehicle cannot move) and verify the
self-test routine is completed as described in section 4.1.
6) If the display monitor shows a coloured overlay indicator, then there are likely to be one or
more objects in the detection area(s) interfering with the test. Move the vehicle to a clear
area and proceed.
7) Verify each detection zone’s distance: Starting from the outside of the detection area, the
operator should check several points along the centre line of the detection width down to
around 0.5m distance from each sensor. The monitor display should show the detection
alerts via coloured on-screen indicators, audible alert frequency and if the trigger outputs
are used, the connected device or function. The operator should note down the distance at
which each detection zone is activated for each sensor and verify that this is in line with
the configuration for this vehicle.
8) Close detection behaviour: Verify objects in between 0.3m and 1.3m distance are only
detected if they move relative to sensor(s). On Screen indicators should show Orange or
Red depending on system configuration.
9) Very close detection awareness: Verify objects less than 0.3m from the sensor are not
detected. Coloured on-screen indicators should switch to standby and audible alert should
switch off after less than 3 seconds.
10) Similar to the previous tests the operator should scan all the edges of the detection area
according to the installed system or configuration for this vehicle. They should note down
the detected locations and check if they match with the detection area set when this
Brigade Backsense
®
System was installed on this vehicle.
To Next Page
Loading...