Briggs & Stratton 12KW User Manual (English)

Other manuals for Briggs & Stratton 12KW

Installation And Operation Manual132 pages

Questions and Answers:

K
kelly15Aug 19, 2025
How to troubleshoot a Briggs & Stratton 12KW that won't start?
- R
  Raymond HernandezAug 19, 2025
  If your Briggs & Stratton Portable Generator engine won't start, or starts and runs roughly, consider the following: 1. Check if the 15 Amp fuse is missing or blown. Install a new 15 Amp fuse. 2. Thermal fuse(s) might be blown. Replace them. 3. Ensure the fuel supply is turned on and not depleted. Open the fuel valve(s) and check the propane tank. 4. Verify that the fuel selection is correct using the fuel selector switch. 5. A failed battery can prevent starting. Replace the battery. 6. A clogged air filter can cause starting issues. Clean or replace the air filter. 7. Check for any binding in the throttle linkage.
M
Matthew SmithAug 21, 2025
Why Briggs & Stratton Portable Generator will not start?
- G
  Gregory FranklinAug 21, 2025
  If your Briggs & Stratton Portable Generator won't start or runs roughly, there are a few things to check. Begin by inspecting the 15 Amp fuse; install a new one if it's missing or blown. Then, make sure the fuel supply is on and not depleted by opening the fuel valve(s) and checking the propane tank. Finally, examine the battery and replace it if it has failed.
P
Pedro OlsenAug 23, 2025
Why does my Briggs & Stratton 12KW Portable Generator engine bog down under load?
- A
  Amanda RobinsonAug 23, 2025
  If your Briggs & Stratton Portable Generator engine runs well without any load but falters when loads are connected, there could be several reasons: 1. The generator might be overloaded. Try removing one or more loads. 2. There could be a short circuit in a connected load. Disconnect the suspected electrical load. 3. It's possible there's a shorted generator circuit, in which case you should contact a local service facility. 4. The fuel pressure or mixture might be incorrect; consult the Gaseous Fuel System section in the manual. 5. A kinked fuel line between the regulator and engine could be the culprit. Remove the kink, and replace the fuel line if necessary. 6. Lastly, a clogged air filter could be restricting airflow. Clean or replace the air filter.
H
hickmanrobertAug 26, 2025
What to do if my Briggs & Stratton 12KW has no AC output?
- R
  rhaleyAug 26, 2025
  If your Briggs & Stratton Portable Generator engine is running but there's no AC output, here are a few things to check: 1. The circuit breaker might be open or defective. Try resetting or replacing the circuit breaker. 2. There might be an alarm on the generator control board. Please, contact a local service facility. 3. Poor wiring connections or a defective transfer switch could also be the cause. Check and repair the wiring connections, or contact a local service facility.
G
garzajeffreyAug 27, 2025
What to do if my Briggs & Stratton 12KW Portable Generator shuts down while running?
- M
  michellelawsonAug 27, 2025
  If your Briggs & Stratton Portable Generator engine shuts down during operation, here’s what to investigate: 1. Check the fuel supply. Make sure the fuel valves are open and the propane tank is full. 2. The control board digital display might be showing an alarm. Please, refer to Alarms section inside the online "Operation Instructions GC1031 GENSET Controller" manual (part number 80086364).
J
Joshua StoneAug 30, 2025
Why am I losing power on circuits with my Briggs & Stratton 12KW?
- P
  Paul ThompsonAug 30, 2025
  If you're experiencing a loss of power on circuits with your Briggs & Stratton Portable Generator, here are a couple of things to check: 1. The generator circuit breaker might be open. Try resetting it. 2. There might be transfer switch problems. Please, see transfer switch manual.
J
Jay ThomasSep 1, 2025
Why won't my Briggs & Stratton 12KW exercise?
- A
  Aaron TurnerSep 1, 2025
  If your Briggs & Stratton Portable Generator unit isn't exercising, consider these potential causes: 1. The control board might not be set to AUTO. Push the AUTO button on the control board. 2. The exercise timer might not be set or is set to OFF. Set the exercise timer. 3. The unit date and time might not be set. Set the unit date and time. 4. The battery might have failed. Replace the battery. 5. A 15 Amp fuse might be missing or blown. Install a new 15 Amp fuse.
M
Michelle HernandezSep 3, 2025
What to do if my Briggs & Stratton 12KW Portable Generator won't stop when utility power returns?
- K
  Kevin SmithSep 3, 2025
  If your Briggs & Stratton Portable Generator does not stop when utility power returns, there might be a few reasons: 1. Blown fuses in the transfer switch. Install new fuses. 2. The 5-minute cool-down period might not have elapsed. Wait 5 minutes. 3. Poor wire connections or defective controllers. Check and repair the connections, or contact a local service facility.
J
Joseph RossSep 5, 2025
Why does my Briggs & Stratton 12KW Portable Generator smell like fuel?
- S
  Savannah FoleySep 5, 2025
  If you notice an odor of fuel from your Briggs & Stratton Portable Generator, it is likely due to a fuel leak. Turn off the manual shutoff fuel valve and contact a local service facility.
B
Bradley SimpsonSep 7, 2025
Why is my Briggs & Stratton Portable Generator vibrating excessively?
- T
  troyalexanderSep 7, 2025
  If your Briggs & Stratton Portable Generator has excessive vibration, it could be due to a loose mechanical fastener. Check and repair or contact a local service facility.

Briggs & Stratton 12KW Specifications

General

Rated Watts	12000
Starting Watts	15000
Engine Brand	Briggs & Stratton
Power Output	12kW
Fuel Type	Gasoline
Outlet Types	4x 120V 20A, 1x 120/240V 30A, 1x 120/240V 50A
Engine Type	4-Cycle OHV