EasyManua.ls Logo

Briggs & Stratton 6421 - Page 3

Briggs & Stratton 6421
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
CAUTION
Installing the 15 Amp fuse could
cause the engine to start at any time without
warning, resulting in minor or moderate
injury.
Observe that the 15 Amp fuse has been removed
from the control panel before servicing.
DO NOT install this fuse until all wiring has been
completed and inspected.
WARNING Certain components in this product and
related accessories contain chemicals known to the
State of California to cause cancer, birth defects, or
other reproductive harm. Wash hands after handling.
NOTICE Only qualified, licensed electricians should
perform this installation, which must strictly comply
with applicable codes, standards, and regulations.
SAVE THESE INSTRUCTIONS - This installation
sheet contains important safety instructions that should
be followed during installation of the equipment.
Safety Alert Symbol and Signal Words
The safety alert symbol
is used to identify safety
information about hazards that can result in personal
injury. A signal word (DANGER, WARNING, or
CAUTION) is used with the alert symbol to indicate the
likelihood and potential severity of injury. In addition,
a hazard symbol may be used to represent the type of
hazard.
DANGER indicates a hazard which, if not avoided,
will result in death or serious injury.
WARNING indicates a hazard which, if not avoided,
could result in death or serious injury.
CAUTION indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE indicates information considered important,
but not hazard-related.
Hazard Symbols and Meanings
Safety
Electrical Shock
Rotating Parts
Auto Start
WARNING
Generator produces hazardous
voltage.
Failure to properly ground generator
could result in electrocution.
Failure to isolate
generator from utility power could result in
death or serious injury to electric utility workers, due
to back-feed of electrical energy.
DO NOT touch bare wires or bare receptacles.
DO NOT use generator with electrical cords which
are worn, frayed, bare, or otherwise damaged.
DO NOT handle generator or electrical cords while
standing in water, while barefoot, or while hands or
feet are wet.
If you must work around a unit while it is operating,
stand on an insulated dry surface to reduce the risk
of a shock hazard.
DO NOT allow unqualified persons or children to
operate or service generator.
In case of an accident caused by electrical shock,
immediately shut down the source of electrical
power and contact the local authorities. Avoid direct
contact with the victim.
Despite the safe design of the generator,
operating this equipment imprudently, neglecting
its maintenance, or being careless could cause
possible injury or death.
Remain alert at all times while working on this
equipment. Never work on the equipment when you
are physically or mentally fatigued.
Before performing any maintenance on the
generator, first disconnect the battery cable
indicated by a NEGATIVE, NEG, or (-). When
finished, reconnect that cable last.
After your system is installed, the generator may
crank and start without warning any time there is a
power failure. BEFORE working on the equipment,
and to prevent possible injury, always set the
generator system switch to OFF, remove the service
disconnect fuse from the disconnect box, and
remove the 15 Amp fuse.
Not for
Reproduction

Related product manuals