Page 10 of 13
4) If equipped, attach the rocker switch ground wire under the control bracket mounting screw (R6).
Complete the connections to the rocker switch as shown below.
STATIC / DYNAMIC GOVERNOR ADJUSTMENT PROCEDURE
IMPORTANT: The governor lever must be replaced any time the static governing is adjusted!
1) While holding throttle wide open, rotate the governor shaft clockwise until it stops.
2) Tighten the governor lever nut to 40 lb-in (4.5 Nm).
3) Hold the throttle against the idle stop screw on the carburetor. Adjust the screw as required to obtain
1450 RPM or 1750 RPM, depending on application.
4) Adjust the high speed screw on variable-speed engines or bend the spring anchor tab on fixed-speed
engines to obtain the equipment manufacturer’s Top No-Load speed (+/- 100 RPM).
Spring Color Hole Position Top No-Load Speed Range
Variable Speed
Blue 3 3400 - 3600
Blue 4 3700 - 3800
Blue 5 3900 - 4200
Red 3 3300
White 3 3000 - 3200
Green 3 2600 - 2900
Fixed Speed
Yellow 3 3200 - 3500
Yellow 4 3600 - 3900
Yellow 5 4000 - 4200
Black 3 2600
Black 4 2700 - 2800
Black 5 2900 - 3100
R6
To Next Page
Loading...
