Page 7 of 13
FLYWHEEL INSTALLATION
1) After installing the flywheel finger guard (L), thoroughly clean and dry the crankshaft taper. Place the
flywheel key in position in the crankshaft keyway.
2) Align the keyway in the flywheel (M) to the key in the crankshaft and press the flywheel into position.
3) Install the flywheel fan (N) and the starter cup (O) to the flywheel. The bosses on the fan and cup
must fit into the corresponding holes in the flywheel.
4) Start the flywheel nut (P) by hand, and then tighten to 65 lb-ft (88.1 Nm).
L
M
P
N
O
To Next Page
Loading...
