28
NOTE: Date and Time were set at the factory and stored in the control panel memory. The Exercise Cycle was
also set at the factory. The default exercise cycle occurs on Tuesdays, at 2:00 P.M. Central Standard Time.
To updated or change these settings, follow the steps below.
IF DURING PROGRAMMING NO BUTTONS ARE PRESSED FOR 30 SECONDS,
THE CONTROL PANEL WILL AUTOMATICALLY EXIT THE PROGRAM MODE.
SET DATE
MONTH
FLASHING
DAY##
FLASHING
YEAR
FLASHING
SET TIME
HOURS
FLASHING
MIN
FLASHING
SET EXERCISE
CYCLE
AM/PM
FLASHING
HOURS
FLASHING
MIN
FLASHING
DAY OF WEEK
FLASHING
AM/PM
FLASHING
EVENT
LOG
Display will scroll last service code event, date, time, and
temperature of when the event occured.
or
OFF
If set to OFF, display will read: EXERCISE CYCLE OFF
or
or
or
or
or
or
or
or
or
or
or
or
or
or
General Set Up Screen
For general set up, press and hold the left arrow and right arrow for 3 seconds. Follow the prompts as outlined below.
To Next Page
Loading...
Need help?
General
