Briggs & Stratton P4500 User Manual (English)

Other manuals for Briggs & Stratton P4500

Questions and Answers:

K
kimberlyfrancoJul 28, 2025
What to do if my Briggs & Stratton Portable Generator engine will not start?
- Z
  zdavisJul 28, 2025
  If your Briggs & Stratton Portable Generator engine won't start, runs rough, or shuts down, there are several potential causes: 1. Ensure the fuel valve is in the on position. 2. Check the oil level and fill the crankcase to the proper level, or place the generator on a level surface if the low oil indicator light is on. 3. Inspect the air cleaner and clean or replace it if it's dirty. 4. Make sure the fuel tank is full. 5. Verify the spark plug wire is connected to the spark plug. 6. If the engine is flooded with fuel, wait 5 minutes before re-cranking.
C
Cathy BookerAug 4, 2025
How to fix a Briggs & Stratton Portable Generator with no AC output?
- B
  Brian ThomasAug 4, 2025
  If your Briggs & Stratton Portable Generator's engine is running but there's no AC output, consider these possibilities: * A circuit breaker may be open; try resetting it. * There might be a poor connection or a defective cord set; check and repair as needed. * The connected device could be faulty; try connecting another device that is in good condition. * A steady red LED light indicates the generator is overloaded or overheated; refer to the Generator Capacity section and press the MAIN RESET button on the control panel.
B
Brandon MeltonAug 11, 2025
Why does my Briggs & Stratton P4500 shut down and the CO Guard LED blinks red?
- A
  Anthony GibsonAug 11, 2025
  If your Briggs & Stratton Portable Generator engine shuts down and the CO Guard LED blinks red, it means the generator is improperly located. Move it to an open, outdoor area. Be sure to air out any nearby premises (e.g., open windows and doors) before reoccupying. Refer to the CO Guard Carbon Monoxide (CO) Shutdown System section for more details.
K
Kyle LeeAug 19, 2025
What to do if Briggs & Stratton P4500 bogs down when load is connected?

Briggs & Stratton P4500 Specifications

General

Running Watts	3700W
Starting Watts	4500W
Engine Displacement	224cc
Fuel Type	Gasoline
Tank Capacity	3.5 gallons
Voltage	120/240V
Run Time at 50% Load	8 hours
Wheels	Yes
Outlet Types	1 x 120/240V 30A Outlet
Starting System	Recoil
Run Time at 25% Load	16 hours