Why Briggs & Stratton engine will not start?
- MMeagan BentonAug 1, 2025
Your Briggs & Stratton Pressure Washer engine might fail to start due to several reasons: 1. The engine rocker switch is set to the OFF (O) position. Solution: Set it to the ON (I) position. 2. Low oil level. Solution: Fill the crankcase to the proper level. 3. Dirty air cleaner. Solution: Clean or replace the air cleaner. 4. Out of fuel. Solution: Fill the fuel tank. 5. Stale fuel. Solution: Drain the fuel tank and fill it with fresh fuel. 6. Spark plug wire not connected. Solution: Connect the wire to the spark plug. 7. Bad spark plug. Solution: Replace the spark plug. 8. Water in the fuel. Solution: Drain the fuel tank and fill it with fresh fuel.