EN
59
8. Presser foot for zip
9. Presser foot for buttonhole
10. Needle ballpoint
FIG. 2
USE
MAINS CONNECTION
OFF
ON
FIG. 3
Check that the mains voltage corresponds to
the rated voltage on the type plate.
Connect the power cord to the product and
plug the plug into a suitable power point. The
power cord connector is not reversible.
The speed is controlled with the pedal.
The speed increases the more the pedal is
pressed.
FIG. 4
The product has LED lighting. The light switches on
automatically when the product is switched on.
FIG. 5
EXTENSION TABLE WITH
ACCESSORY STORAGE
The extension table provides more workspace
and can easily be removed when sewing with
free arm.
Sewing with free arm
Pull the extension table away from the product
as shown in the gure.
FIG. 6
Fitting the extension table
Align the guide pins and press the extension
table on the product.
FITTING
/
REMOVING PRESSER FOOT
Removing
1. Turn the hand wheel towards the front of
the product until the needle is in its top
position.
2. Bring up the presser foot.
FIG. 7
3. Press the arm on the back of the presser
foot holder.
4. The presser foot comes loose.
FIG. 8
Fitting
Put the presser foot with the axle under the
slot in the presser foot holder. Move down the
presser foot holder to lock the presser foot in
place.
FIG. 9
REPLACING NEEDLES
1. Lift up the needle by turning the hand
wheel towards the front of the product
and bring down the presser foot.
FIG. 10
2. Switch o the product and pull out the
plug.
3. Turn the needle screw anticlockwise
to release. Undo the needle screw just
enough for the needle to come loose.
4. Remove the needle from the needle
holder.
5. Put a new needle in the needle holder
with the at side turned towards the back
of the product.
6. Press the needle up as far as it goes and
rmly tighten the needle screw with the
screwdriver. Do not overtighten, this can
cause the needle bar to break. Thread the
needle.
To Next Page
Loading...