BRIGHT 024574 - Automatic Needle Threading; Straight Stitch

EN
62
NOTE:
It can be easier to thread the needle if the
end of the thread is cut with a sharp pair
of scissors. Switch on the product when the
threading of the underthread and top thread
is nished. The product is now ready to use.
Automatic needle threading
This function is only available if the product has
an automatic needle threader.
1. Bring down the presser foot.
2. Bring up the needle.
FIG. 30
3. Move down the needle threader arm
slowly. Place the thread round the hook
(A).
FIG. 31
4. Bring down the arm to the lowest
position. The thread hook passes through
the eye of the needle.
5. Pull the thread to the right under the
hook (A).
FIG. 32
NOTE:
The needle threader can be used with needle
sizes 11, 14 and 16.
6. Hold the thread lightly and release the
arm. A thread loop goes through the eye
of the needle.
FIG. 33
7. Pull out the thread through the eye. Pull
10 cm of thread under the presser foot.
FIG. 34
PULLING OF UNDERTHREAD
1. Lift the presser foot and hold the top
thread lightly with the left hand.
FIG. 35
2. Turn the hand wheel slowly with the right
hand towards the front of the product
so that the needle moves down. Turn
until the thread guide arm reaches its
top position. Carefully pull up the top
thread, which brings with it a loop of the
underthread.
FIG. 36
3. Pull out both threads 15 cm back under
the presser foot.
FIG. 37
ADJUSTING THE TENSION OF THE
TOP THREAD
Almost all sewing is done with the knob for
the top thread tension over the product set to
position 4.
Adjusting to a somewhat higher or lower
setting can make the sewing look better.
Correct tension.
1. Top
2. Bottom
FIG. 38
The top thread is too tight.
Reduce the tension.
FIG. 39
The top thread is too loose.
Increase the tension.
FIG. 40
Straight stitch
The quality of the sewing depends on whether
the top thread is correctly tensioned in relation
to the underthread. The tension is correct
when the two threads are locked in the middle
of the fabric being sown. The tension must
be adjusted if the stitches are uneven. First
check that the top thread and underthread are
correctly tensioned.