Brightz Canopy Series User Manual (English)

To Next Page

Canopy Brightz

™

Instructions

Step 1 – Install Batteries

Open latches on the side of the battery pack to access batteries. Install 3 fresh AA batteries,

observing correct polarity (+/-). Close the battery pack, making sure the latches snap shut.

Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or rechargeable

(nicad, ni-mh, etc.) batteries.

Caution: Batteries may explode or leak, and cause burn injury if recharged, disposed of in fire,

mixed with a different battery type, or inserted backwards. Replace all used batteries at the same

time. Clean battery contacts and contacts on the device prior to installing. Remove batteries if item

will not be used for long periods of time. When battery expires remove promptly.

Step 2 – Install Battery Pack

Attach the battery pack to the frame of your canopy or patio umbrella using the included silicon

strap.

We recommend:

• For canopies, place on one of the collapsible braces at the top of the canopy leg.

• For patio umbrellas, place near one of the umbrella points.

Take the silicon strap and loop one of the end holes over the T-hook on the side of the battery pack.

Place the battery pack against the canopy or umbrella, pull the silicon strap around the frame, and

secure it on the other T-hook.

Latches

(see reverse side for a diagram of each option)

Need help?

Do you have a question about the Brightz Canopy Series and is the answer not in the manual?

Brightz Canopy Series Specifications

General

Explains battery safety, handling, and disposal precautions.

Instructions for attaching the battery pack to canopy or umbrella frames.

Details how to attach clips to fabric and insert light strings.