Brightz Toss Brightz User Manual

Toss Brightz
™
Installation Instructions
©Copyright Brightz, Ltd. 2015
Patent Pending
All rights reserved
Step 1 – Install batteries
From the BACK of the battery holder slide the back up to remove the battery cover. Install 3 fresh AA batteries,
observing the correct
polarity (+/-). Replace battery cover. Do not mix old and new batteries and do not mix
alkaline, standard
(carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries.
Step 2 – Positioning and installing the LED lights around the hole
Turn board over so the back side is facing up and attach LED lights using three (3) screw-in fasteners as shown.
Adhere the battery pack to the board with the attached hook and loop fastener. NOTE: Lights are waterproof
but battery pack is not.
TOP END OF BOARD
Clip
Clip
Clip

Brightz Toss Brightz Specifications

General

Brand	Brightz
Model	Toss Brightz
Category	Lighting Equipment
Language	English

Summary

Battery Installation

Install AA Batteries

Instructions for inserting 3 fresh AA batteries into the battery holder, observing polarity, and replacing the cover. Avoid mixing battery types.

LED Light Installation

Mounting LEDs Around Hole

Attach LED lights using screw-in fasteners and adhere the battery pack with hook and loop fastener to the board's back.

Exterior LED Lighting Setup

Board Edge LED Placement

Install LED lights on the board's exterior using clips and nails, working counterclockwise for optimal battery access.