Brightz Canopy User Manual

canopybrightz
™
Instructions
© Copyright Brightz, Ltd. 2019
Patent Pending • All rights reserved
Step 1 – Install Batteries
Open latches on the side of the battery pack to access batteries. Install 3 fresh AA batteries,
observing correct polarity (+/-). Close the battery pack, making sure the latches snap shut.
Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or rechargeable
(nicad, ni-mh, etc.) batteries.
Caution: Batteries may explode or leak, and cause burn injury if recharged, disposed of in fire,
mixed with a different battery type, or inserted backwards. Replace all used batteries at the same
time. Clean battery contacts and contacts on the device prior to installing. Remove batteries if item
will not be used for long periods of time. When battery expires remove promptly.
Step 2 – Install Battery Pack
Attach the battery pack to the frame of your canopy using the included silicon strap.
We recommend pl
acing it on one of the collapsible braces at the top of the canopy leg.
Take the sil
icon strap and loop one of the end holes over the T-hook on the side of the battery pack.
Place the battery pack against the canopy brace, pull the silicon strap around the frame, and secure
it on the other T-hook.
Latches

Brightz Canopy Specifications

General

Brand	Brightz
Model	Canopy
Category	Lighting Equipment
Language	English

Summary

Install Batteries

Battery Installation Procedure

Instructions for opening the battery pack, inserting 3 AA batteries with correct polarity, and closing the pack.

Battery Safety and Warnings

Crucial safety information regarding battery mixing, recharging, disposal, and potential hazards.

Install Battery Pack

Attaching Battery Pack with Strap

Instructions for securing the battery pack to the canopy frame using the included silicon strap.

Set Up Light Strings

Using Installation Clips for Lights

Guidance on using clips to attach light strings to canopy fabric edges for optimal spacing.