Page 8 BRIGON 500 NT
Print
To print out the readings from the current display or from the memory cell press
the button shortly and quickly release it. The analyser displays „Printing“
until this is complete. Press and release the key again to abort printing.
Back
lighting
Press the button shortly. Backlighting of the display and pocket light turns
ON or OFF.
Be aware, that using the lights increases the power consumption of the batteries
and leads to a shorter opereating time.
Pump
The analyser normally operates with the pump on in any measuring mode. Press
the button shortly to switch the pump OFF or ON again.
When the pump is switched off, the analyser displays -PO- (Pump off) in the
corresponding display line and a double beep sound comes regularly.
Attention: the pump will not switch OFF if CO-reading is above 20 ppm. It
helps to protect the CO sensor from damage.
Zero
pressure
sensor
Press and hold the button. The top line of the display shows „CAL ZERO“.
Storing
the
readings
To store the reading, press and hold the button until the top line display
shows „LOG NO“.
The instructions on viewing and printing the stored readings you can find in
chapter MENU/Report (see next page).
Memory
capacity
Your BRIGON 500 NT can store different readings:
Stack loss readings: 99 memory cells
Tightness test: 20 memory cells
Differential temperature readings: 20 memory cells
CO readings in ambient air: 20 memory cells
At the end of the measurement the next available memory cell is taken
automatically, for example LOG 02, to store the readings.
To view the stored data press the buttons in the measuring mode untill
the analyser shows „DISPLAY“ and confirm it with the button. You can
choose storage cells by pressing the buttons and confirming your
choice with the button.
To Next Page
Loading...