Brildor Combo Craft Express - Hip Flask Heater Guide; Installing the Hip Flask Heater; How to Print a Hip Flask

12 pages

To Next Page

To Previous Page

15 16

Combo Heat Press MachineCombo Heat Press Machine

HOW TO PRINT A HIP FLASK?

1 Fix the image on the hip flask

with heat-resistant tape;

4 Set the printing time and

temperature;

2 Adjust the printing pressure;

6 Press down the handle, and

the machine will start the

countdown automatically;

5 As the machine heats up to the

set temperature, put the hip

flask on the attachment;

7 After the countdown, lift up

the handle;

3 Turn on the machine;

8 Check the amazing printout

result!

HOW TO INSTALL THE HIP FLASK HEATER?

Secure the bottom with screws;4 Secure the hip flask heater with

screws;

Remove the screws from the board;3

6 Plug in the connect cable, and the

installation is complete!

1 Turn off the machine; 2 Remove the heating platen;

brildor.com