Brinkmann 810-1201-S - User Manual

Questions and Answers

L
Lucas GarciaAug 17, 2025
What to do if Brinkmann 810-1201-S Grill has flare-up?
- F
  Francisco ReevesAug 17, 2025
  A flare-up on your Brinkmann Grill is often due to grease buildup. Clean all grill parts following the “Proper Care and Maintenance” instructions. Excess fat in the meat can also cause flare-ups, so trim the fat before grilling. Finally, excessive cooking temperature might be the culprit, so adjust the cooking temperature to a lower setting.
L
Lauren JonesAug 21, 2025
What to do if Brinkmann Grill has grease fire?
- V
  Victor ChanAug 21, 2025
  If you experience a grease fire in your Brinkmann Grill, it's likely due to grease trapped by food buildup around the burner system. Immediately turn the control knobs and LP gas tank valve to “OFF”. Leave the lid either open or closed and let the fire burn out. If necessary, use a BC type fire extinguisher or baking soda, sand, or dirt to smother the fire. After the grill cools, remove and clean all parts per the “Proper Care and Maintenance” instructions.
S
shepherddanielleAug 25, 2025
Why my Brinkmann 810-1201-S does not get hot enough?
- A
  andrewmoralesAug 25, 2025
  If your Brinkmann Grill isn't getting hot enough, the first thing to check is whether you are out of gas. If so, replace or refill the LP gas tank. Additionally, the flow limiting device might have been activated. Try a mini reset by turning the control knobs and LP gas tank valve to “OFF”, waiting one minute, and then relighting the grill per the “Lighting Instructions”. If the flames are still too low, perform a full reset: turn everything “OFF”, disconnect the regulator from the propane tank, inspect the LP cylinder rubber seal, wait 1 minute, reconnect the regulator, perform “Leak Testing” on all connections, and then light the grill per the “Lighting Instructions”.
C
Carla RobertsAug 27, 2025
Why is the flame yellow or orange on my Brinkmann 810-1201-S Grill?
- A
  Anthony SellersAug 27, 2025
  If the flame on your Brinkmann Grill is yellow or orange, it could be due to a few reasons. If it's a new burner, it may have residual manufacturing oils; burn the grill for 15 minutes on “HIGH” with the lid closed. Another cause could be spider webs or insect nests in the venturi, so clean the venturi and burner assembly. Food residue or grease can also cause this issue, so clean the burner assembly. Finally, ensure the burner venturi is properly engaged with the valve; refer to the “Burner Adjustment” section for guidance.
C
Christopher MillsAug 30, 2025
Why does the flame blow out on my Brinkmann 810-1201-S Grill?
- B
  Bradley HillAug 30, 2025
  If the flame on your Brinkmann Grill blows out, it could be due to high or gusting winds; avoid using the grill in high winds. It might also be due to low LP gas, so replace or refill the LP gas tank. Obstructed burner holes can also cause this, so refer to the “Burner Assembly/Maintenance” instructions. Finally, the flow limiting device might have tripped; refer to the “Regulator Resetting Procedure”.
I
Ian PerezSep 3, 2025
How to fix irregular flame pattern on Brinkmann 810-1201-S Grill?
- T
  Travis MartinezSep 3, 2025
  An irregular flame pattern on your Brinkmann Grill, where the flame doesn't run the full length of the burner, is often caused by clogged or blocked burner ports. Clean the burner ports to resolve this issue. Additionally, the air shutter on the burner may need adjustment; refer to the “Burner Adjustment” section for guidance.
N
natalieharperSep 6, 2025
What causes flashback (fire in burner tubes) / knobs melting on Brinkmann Grill?
- J
  John WallaceSep 7, 2025
  Flashback, or fire in the burner tubes, along with melting knobs on your Brinkmann Grill, indicates that the burners and/or burner tubes are blocked. Clean the burners and/or burner assembly to resolve this issue.
S
Sharon JonesSep 9, 2025
Why is the inside of my Brinkmann Grill lid peeling?
- B
  Brian MendezSep 9, 2025
  If the inside of your Brinkmann Grill lid is peeling, resembling paint peeling, it's likely due to baked-on grease buildup that has turned into carbon and is flaking off. Clean the grill thoroughly per the “Proper Care and Maintenance” instructions.
J
James StewartNov 13, 2025
How to fix Brinkmann 810-1201-S burner that will not light?
- D
  Daryl SmithNov 13, 2025
  If the burner on your Brinkmann Grill won't light, start by ensuring the LP gas tank valve is open and the regulator is securely attached. Also, check if the LP gas tank is low or empty and replace or refill it if necessary. If there's a gas leak, turn the LP gas tank valve to “CLOSED”, wait 5 minutes, and follow the “Leak Testing” instructions in the owner’s manual. Make sure the coupling nut and regulator are fully connected, referring to the “Connecting Hose and Regulator” section. Check for obstructions in the gas flow by cleaning the burner assembly and inspecting for bent or kinked hoses. Reseat the burner and valve, following the “Burner Assembly/Maintenance” instructions. Clean the venturi and burner assembly to remove any spider webs or insect nests. Clean any clogged or blocked b...