BRINKS Push Pull Rotate - Step 11: Handleset Operation

999-00370E_EN
b.
c.
a.
OUTSIDE VIEW
INSIDE VIEW
Inside Lever
ROTATE UP
ROTATE DOWN
PUSH
PULL
TOP VIEW
LIMITED LIFETIME WARRANTY- This product is warranted by Hampton Products International (“HPI”) with a limited lifetime mechanical and nish warranty to the original consumer user of this product against defects in material and workmanship under normal use and service as long as
the original consumer user occupies the residential premises upon which this product was originally installed. This warranty does not apply to product: used in commercial or common area applications; used for purposes for which it was not designed or intended; and which has been
abused, misused, modied, or improperly installed, operated, maintained, and/or repaired. This warranty does not cover scratches, abrasions, or deterioration due to the use of paints, solvents, or other chemicals. HPI IS NOT LIABLE FOR INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you. This warranty provides you with specic legal rights and you may also have other rights that vary from state to state. To make a warranty claim, please
contact Hampton Care at 1-800-562-5625 or visit our website at www.hampton.care for instructions on how to have the product replaced, exchanged for a similar product of equal value, or repaired.
BRINKS A TRUSTED NAME IN SECURITY SINCE 1859 and all related logos
are trademarks or registered trademarks of Brink’s Network, Inc,
and are used with permission.
50 Icon, Foothill Ranch, CA 92610-3000 USA
1-800-562-5625 • www.Hamptonproducts.com
©2020 Hampton Products International Corp.
www.brinksppr.com
999-00370E_EN_REVB 03/20
a. To open the door from the outside, push the
upper section of the handle to retract the latch
bolt.
b. To open the door from the inside, rotate the
lever either up or down, OR...
c. Pull the lever to retract the latch bolt.
Tip: Always contact the lever near the end for
best leverage.
Handleset Operation
STEP 11