==================================================================================================
PROBLEM CAUSE/CONDITION REMEDY
Slow
Ground
Entry
1. Improper crank
2. Badly worn plow share.
3. Ground extremely dry and
hard due to lack of moisture.
4. Hitch downward movement
restricted by mower
CLOCKWISE 1 or 2 turns at a time.
2. Replace with a new share.
3. Add extra weight to tractor or wait until soil conditions
are suitable.
Plow Cutting
Too Wide
1. Improper tracking
Tracking
Issues
left or Leaves a ragged wall.
1. See "Tracking Adjustment" section, on page 15.
Plow Bottom
Won't Polish
1. New or rusted
bottom.
1. Clean bottom frequently during use until polish is obtained by:
- Clean bottom with a rag soaked in turpentine or mineral spirits.
- Old brick or pumice may also be used to polish bottom.
- Rub with a rag soaked in oil and dipped in sand.
Uneven
Plowing
Depth
1. Extreme variations in soil
texture and/or moisture.
soil, runs shallow.
1. See plowing tips. Soil too wet or dry.
MAINTENANCE
TROUBLESHOOTING
(Plowing difficulties and remedies).
USE AND CARE
- CONDITION: The moldboard should
smooth, polished condition. Fine sandpaper, steel wool,
on a rusty moldboard.
- SHARPENING: The coulter blade edge should be
- COULTER HUB BEARING: Every 4 hours lubricate the
NOTE: When lubricating bearing, it is recommended that
you use multipurpose grease.
- PREVENT RUST: For smooth operation and to prohibit
the formation of rust on the crank, keep a light coating of
oil on threads.
QUALITY CONTINUES
WITH QUALITY SERVICE
If you have installation questions, are missing parts
or need replacement parts, don’t go back to the store!
then contact our Customer Service department:
SERVICE
In North America and Canada call
Toll-Free: 877-728-8224
Chat online: www.brinly.com
Email: customerservice@brinly.com
17 L-1043-3-BEnglish Manual
To Next Page
Loading...
